Hints On Closing Your Pool

Above Ground Winterizing
Tips Warnings and Instructions

We recommend not draining below the skimmer use a Gizzmo or SkimSaver

PROPERLY WINTERIZING YOUR POOL REQUIRES 3 IMPORTANT Steps

• Using the correct winter chemicals to avoid damage to the pool
• Correctly winterizing your equipment to avoid freeze damage
• Correctly winterizing the pool to avoid damage

Step 1

1. Clean the pool and vacuum any debris that might be in the water. Closing a dirty pool will result in serious problems next spring.
2. After the pool has been cleaned, add enough chlorine to bring the test reading to at least 1.5ppm.
3. Adjust pH to a reading of 7.2-7.8
4. Add our Winter Chemicals as indicated on the kit instructions.
5. Allow pump to circulate water for at least 1 hour.

Step 2

1. Install any plugs as necessary.
2. Winterize skimmer using either the Skimsaver or a Gizzmo Found on the previous page
3. Disconnect all hoses from pool, filter and pump as necessary.
4. Remove drain plugs from filter tank.
5. Open strainer pot and remove all water from pump. Remove any drain plugs.
6. If filter system will not be stored inside, replace all lids to keep rain out.
7. Remove ladder from water. Clean and store away.

Step 3

1. Clean and inspect exterior surfaces of the pool. Repair any scratches with rust proof paint or clear fingernail polish. Pay particular attention to the areas around the skimmer and inlets. Leaky fittings and gaskets can cause corrosion. Those of you that have decks that cover skimmers and inlets should make a special effort to inspect those unseen areas.
2. To eliminate ice damage to the liner use the following protection method.

• Vinyl air pillow made especially for this purpose

3. Attach cover as recommended by the manufacturer.
4. Add more Winterizer in January and March.